Booster Car Seat Instruction Manual• Certified for use in motor vehicles• Meets or exceeds all aplicable requirements ofFederal Motor Vehicle Safety S
9Lap belts that have a retractor that locksonly in case of a sudden stop (emergencylocking retractor or ELR) (Fig. 7)Lap-shoulder belts with seat belt
10Do not install this booster car seat in a vehicle seating position using thek-fix connectors if:The seat belt is located between the lower LATCH anc
114.3 Kiddy k-fix systemThe kiddy k-fix system provides additional security by using the loweranchors of the vehicle LATCH (Lower Anchors and Tether f
1.To adjust the headrest height rotate thehandle out gently and raise or lower theheadrest to position the narrow area of theheadrest in line with the
6.1 Installation using k-fix:1. The guide funnels may allow an easierinstallation into your vehicle. Install the guidefunnels onto the lower anchors.
2. Place the booster car seat on the vehicleseat. To extend the k-fix connectors, press therelease button in the front under the legextension (Fig. 16
156.2 Securing your child:1. Place the child in the booster car seat withhis or her back flat against the seatback.2. Pull out vehicle three point lap
166. Slide the upper shoulder belt into theshoulder belt guide on the booster car seat’sheadrest on the side opposite vehicle buckle(Fig. 22).7. The s
17- Shoulder belt snugly adjusted, contacting chest, belt guide at or aboveshoulder, and centered on shoulder.- Child must be sitting upright in boost
182. Open both left and right k-fix connectors (E)by pressing the release mechanisms (N)towards the front (past the green lock indicator(O)) (Fig. 27)
(B) shoulder beltguides(A) booster car seat(P) backside(E) k-fixconnector(E) k-fix Connector(C) backrest(D) arm rest(F) shockabsorber(G) funnels(N) re
199.1 Removing the headrest coverThe headrest and backrest cover are sewn together as a single unit.Slide the adjustable headrest (F) up to the highes
20- Do not use bleach, drip dry.- Do not spin or place in a tumble dryer.- The covers are an essential component of the safetydesign. Therefore, you s
21PLEASE COMPLETE AND MAIL THE OWNER REGISTRATION CARDWITHIN (30) DAYS OF PURCHASE OR REGISTER ONLINEhttp://kiddyusa.com/registration_carseat.htmlLIMI
22Although child restraint systems undergo testing and evaluation, it ispossible that a child restraint could be recalled. In case of a recall, we can
kiddy USA, Inc.685 Dividend Dr.Peachtree City, GA 30269Phone: 1-855-92-KIDDYE-mail: [email protected]
ENGTable of contents1. Introduction... 32. Recommended use...
• Child must be at least 33 lbs (15.0 kg) and 38 in. (96 cm) to use thisbooster car seat.• Discontinue use of booster car seat when:- The child exceed
3. Genaral Safety Warnings4ENG• Failure to follow the instructions and labels can result in serious injury ordeath from ejection or contacting the veh
5ENG• Allow your child to take breaks during longer trips, and be sure that she /he does not step out of the vehicle into traffic unattended.• Always
64. Choosing a vehicle seating position and preparing to installthe booster car seat4.1 Vehicle seat location requirements:According to crash statisti
7Please familiarize yourself thoroughly with the recommended use of carseats as described in your vehicle’s owners manual.This booster car seat MUST b
8Vehicle belts with top or bottom anchorpoints on the vehicle door (Fig. 4)Lap-shoulder belts that have a separateretractor each for the lap section a
Kommentare zu diesen Handbüchern